How to replace the blower motor resistor on 2010 Chevrolet Aveo?

When replacing the Blower Motor Resistor start by disconnecting the negative Battery Cable along with its electric connector at the resistor. Carefully take out the resistor by pulling it down when you disconnect its retaining screws. Set the new resistor into the heater/air distribution case through its fitting then tighten screw connections at 6 nm (53 lb in). Rejoin the electrical connector to the new resistor before connecting the negative Battery Cable. End tests by verifying that the blower operates correctly.

OEM 2010 Chevrolet Aveo Blower Motor Resistor

Heater Blower Motor Resistor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blower Motor Resistor found

View related parts
2010 Chevrolet Aveo Resistor
Part Number: 96435889
$31.40 MSRP: $56.84
You Save: $25.44 (45%)
Ships in 1-2 Business Days
ADD TO CART
Product Specifications
- Other Name: Resistor, Blower Motor; Blower Motor Resistor; Resistor, A/C Evaporator Blower
- Replaces: 96539658
- Item Weight: 0.50 Pounds
- Item Dimensions: 4.4 x 4.2 x 2.2 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 96435889
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2010 Chevrolet Aveo Submodels:
- Base, LS, LT, Special Value | 4 Cyl 1.6 L GAS

2010 Chevrolet Aveo Blower Motor Resistor

With a comprehensive array of OEM 2010 Chevrolet Aveo Blower Motor Resistor, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2010 Chevrolet Aveo Blower Motor Resistor are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2010 Chevrolet Aveo Parts Questions & Experts Answers

Q: How to replace the blower motor resistor on 2010 Chevrolet Aveo?
A: When replacing the Blower Motor Resistor start by disconnecting the negative Battery Cable along with its electric connector at the resistor. Carefully take out the resistor by pulling it down when you disconnect its retaining screws. Set the new resistor into the heater/air distribution case through its fitting then tighten screw connections at 6 nm (53 lb in). Rejoin the electrical connector to the new resistor before connecting the negative Battery Cable. End tests by verifying that the blower operates correctly.