OEM 2010 Chevrolet Cobalt Blower Motor

2010 Chevrolet Cobalt Parts Questions & Experts Answers

• Q: How to replace the blower motor on 2010 Chevrolet Cobalt?

  A: The first step to replace the Blower Motor involves unplugging its electrical connector. Use a small chisel to remove the lower Blower Motor heat stakes before taking out the lower Blower Motor cover. You should take apart the Blower Motor nuts while trying to make straight cuts through the case to reuse the motor cup and avoid making unnecessary damages to the unit. Use a sharp utility knife to cut through the motor case between its circular ribs and take out the lower case blower. To detach the Blower Motor remove the retaining tab holding it into the cup. Position the Blower Motor into the removed motor cup base before installing its nuts at 2.4 nm (21 lb in). Use the kit screws to mount the service ring onto the motor cup while tightening both to 1.8 nm. Driver the hvac module screws through the Blower Motor and service ring assembly, keep the Blower Motor electrical connector facing the vehicle rear end, and tighten the screws to 1.8 nm (15 lb in). Place the bottom Blower Motor panel and fasten it with retaining screws. Tighten the screws to 1.8 nm (15 lb in) while connecting the Blower Motor electrical wire.