OEM 2010 Chevrolet Corvette Timing Cover

2010 Chevrolet Corvette Timing Cover Parts Questions & Experts Answers

• Q: How to replace the engine front timing cover (except 6.2L (LS9) and 7.0L) on 2010 Chevrolet Corvette?

  A: The engine front cover replacement process (except 6.2L (LS9) and 7.0l) begins by removing the crankshaft balancer then the Water Pump. Front cover bolts (501) need removal which allows you to detach front cover (502) with gasket (503) so discard the gasket. The engine front cover requires cleaning followed by inspection. Remove the oil seal (140) and bolts (705, 738) and Camshaft Position Sensor (703) together with wire harness (737) while shutting down the o-ring (704) from the sensor if required. When installing the component apply a 0.2 inch (5mm) bead which should be 0.8 inches (20mm) long onto the tabs where they extend into the oil pan surface of the engine block. Install the front cover gasket (503) ensuring both gasket surfaces show no signs of oil or foreign material contamination while maintaining the crankshaft front oil seal at its center point on the crankshaft. Position the front cover gasket (503) along with front cover (502) and bolts (501) on the assembly before tightening the bolts only to finger tight specifications. Position the j 41480 tool onto the engine block and torque the bolt assemblies to 25 nm (18 lb ft) while directing the tool's tapered legs to match the corresponding machined surfaces on the front cover. Begin by installing j 41476 before adding the crankshaft balancer bolt but tighten everything just until they become secure by hand. After tightening the j 41480 bolts along with engine front cover bolts to 25 nm (18 lb ft), remove the tools. Measure the oil pan surface flatness between the front cover and engine block by checking that the cover matches the engine block perfectly or remains not more than 0.5 mm (0.02 in) below level. The alignment process needs to be redone or the front cover needs replacement when specifications are not met. The Camshaft Position Sensor o-ring seal (704) should be checked for any damages before lubricating it with engine oil and placing it onto the sensor (703). Secure the sensor to the cover while you thread the Camshaft Position Sensor wire harness (737) with bolts (705, 738) before tightening the bolts to 12 nm (106 lb in). As the final step install the Water Pump together with the crankshaft balancer.