Other Name: Lever Assembly, Automatic Transmission Control; Automatic Transmission Selector Handle; Gear Shift Assembly; Lever, Transmission Control Lever
Replaces: 10258091, 26056013
Fits the following Buick Models:
Century | 1997-2005 | Custom, Limited, Special Edition | 6 Cyl 3.1 L GAS
LeSabre | 2000-2005 | Custom, Limited | 6 Cyl 3.8 L GAS
Park Avenue | 1997-2005 | Base, Ultra | 6 Cyl 3.8 L GAS
Regal | 1997-2001 | 25th Anniversary Edition, GS, GSE, LS, LSE | 6 Cyl 3.8 L GAS
Other Name: Lever Assembly, Automatic Transmission Control; Automatic Transmission Selector Handle; Gear Shift Assembly; Switch; Lever, Transmission Control Lever
Replaces: 26056014
Fits the following Buick Models:
LeSabre | 2000-2005 | Custom, Limited | 6 Cyl 3.8 L GAS
Park Avenue | 1997-2005 | Base, Ultra | 6 Cyl 3.8 L GAS
Q: How to Replace Automatic Transmission Shift Levers on Buick LaCrosse?
A: The first step for shifting lever replacement requires disabling the sir system. The shift lever seal should slide up the shift lever shaft. Steering column trim covers must be removed if needed. To replace the shift lever first disconnect the base of the column connector and then unscrew the shift lever screw attached to the shift lever assembly. Gently pull out the shift lever along with its seal from the linear shift assembly by sliding the seal towards its thin part on the shift lever. Start by inserting the shift lever seal onto the shift lever assembly before installing the assembly onto linear shift assembly. The shift lever screw requires installation into the shift lever assembly before tightening it to 20 n.m (15 lb ft). The shift lever seal should be slid downward along the shift lever assembly until it reaches the position of the steering column trim covers. The next step is to install the steering column trim covers and finally enable sir system after completion.
Q: How to Assemble Automatic Transmission Shift Levers Off on Buick LeSabre?
A: Before assembling the shift lever off the car, put the shift lever seal on the shift lever assembly . After that, use the shift lever screw to fasten the shift lever assembly, making sure the torque is 1.5 Nm (13 inch lbs.). Connect the shift lever connector, and then insert the wire harness assembly into the clip and make sure the wire straps are secured. At the end, put the upper and lower shrouds onto the shift lever.