Other Name: Knob, Front Seat Back Reclining *Jet Black; Power Seat Switch; Recline Knob; Knob; Knob, Front Seat Back Reclining; Knob, Seat Adjuster/Recliner
Position: Passenger Side
Fits the following Buick Models:
LaCrosse | 2014-2016 | Base, Leather, Premium, Sport Touring | 4 Cyl 2.4 L MILD HYBRID EV-GAS (MHEV), 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
Q: How to replace the power seat switch on Buick Rendezvous?
A: The power seat replacement process begins by taking away the outer trim panel installed on the front seat cushion. A flat-bladed tool will help you free the retainers which hold the power seat switch to the outer trim panel to allow removal of the switch. The power seat switch harness should be disconnected from the front seat support while also removing the electrical connector from the switch. You need to position the electric connector to the power seat switch and after that apply pressure to the switch until it fully reaches the outer trim panel space and verify that the power front seat switch harness is positioned correctly for outer seat cushion trim panel alignment. Connect the power seat switch harness with the front seat support before you reinstall the outer trim panel on the front seat cushion.
Q: How to replace the memory seat switch on Buick LeSabre?
A: A small flat instrument will help you slowly extract the memory seat switch from the door trim panel for its replacement. Remove the plug first before taking out the electrical connector. When installing the memory seat switch start by joining the electrical connector to the switch followed by alignment of the switch within the door trim opening until the switch snaps into its position.
Q: How to Remove and Replace a Power Seat Switch on Buick Century?
A: The first step for replacing the power seat switch is to uninstall the front seat cushion outer trim panel. Begin by removing the screws which keep the seat switch attached to the trim panel then disconnect the power front seat switch electrical connector. Take the power front seat switch out of the vehicle after its removal. The electrical connector needs to be connected to the power front seat switch with special attention to Fastener Notice instructions during installation. Fasten the seat switch onto the trim panel by applying screws which require a torque of 3 Nm (27 lb in). After completing the task reinstall the front seat cushion outer trim panel.