Q: How to replace the Body Control Module (BCM) on Buick LaCrosse?
A: Take proper steps to fight electrostatic discharge (ESD) before you start replacing the Body Control Module (BCM). Take out the left instrument panel outer trim first and use a press to release the cam lock. Disconnect the upper electrical connector from the BCM. First disconnect the knee bolster before taking out the left I/P insulator. Following this press the cam lock to take off both lower BCM electrical connectors. Take the BCM bracket screws out and remove the BCM and bracket from their I/P position to split them apart. Before mounting, place the BCM on the BCM bracket then install the unit into its original position by tightening its screws to 2 N.m (18 lb in). Secure the lower BCM electrical connectors using the cam lock before putting back the knee bolster and left I/P insulator. Connect the BCM's upper electric socket and fix it with the cam lock before installing the left I/P panel. Complete the new BCM installation process according to necessary specifications.
Q: How to remove and install the Body Control Module (BCM) on Buick Regal?
A: Disconnect the battery negative terminal before taking out the left instrument panel insulator. Pull out all bcm electrical connectors before pushing the unit upward to release it from the slot and remove it. Choose bcm type 2 for retained accessory power (RAP) with audible warnings and interior lighting plus automatic power door locks, type 3 for keyless entry and type 4 for content theft deterrent ctd plus keyless entry features. Put the top section of the bcm into the mounting bracket slot and push the bottom part into the location as you hold the setup vertically. First connect the bcm electrical wires then replace the left instrument panel pad and lastly reconnect the battery negative terminals.
Q: How to replace the Body Control Module for the door on Buick LeSabre?
A: You need to take off the door trims first before disconnecting electrical connections to work on the Door Control Module. After disconnecting the electrical connectors you need to take out the door control module by removing its fasteners. Place the door control module into position and fasten it with its hardware items. Then tighten the hardware pieces to 7 N.m according to the Fastener Notice in Service Precautions. Relace the door trim panel once you have connected all electrical wires.