Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2007-2020 Cadillac Escalade | Base, Hybrid, Hybrid Platinum, Luxury, Platinum, Premium, Premium Luxury | 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV), 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
| Page 1 of 2 |Next >
1-20 of 25 Results
Cadillac Escalade Exhaust Heat Shield
Our website offers an extensive catalog of genuine Cadillac Escalade Exhaust Heat Shield at unbeatable prices. Every OEM Cadillac Escalade Exhaust Heat Shield comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Cadillac Escalade Exhaust Heat Shield Parts Questions & Experts Answers
Q: How to replace the exhaust heat shield on the dash panel on Cadillac Escalade?
A: Begin the Exhaust Heat Shield replacement on the dash panel by supporting the vehicle while it is in an elevated position. Start by removing both the shield bolts attached to the engine then take out the shield if required. Owners of 1500 series vehicles should remove bolts from the skid plate for the oil pan while also unwiring the skid plate if the vehicle has this component. The process begins by loosening the rear bolts of the oil pan skid plate on 2500 series vehicles before removing both front oil pan skid plate bolts and skid plate when it is present. Catalytic Converters must be taken off in case they are needed for replacement. Proceed by removing the dash panel Exhaust Heat Shield nuts (2 or 4) as well as the dash panel Exhaust Heat Shield (1 or 3) from dash panel studs. For attachment install the dash panel Exhaust Heat Shield (1 or 3) onto dash panel studs by closely following fastener safety recommendations. Secure the screws that hold the dash panel Exhaust Heat Shield (2 or 4) by tightening them to 9 nm (80 lb in). Installation of the Catalytic Converter should be performed when needed. Vehicle installation for 2500 series requires placing the oil pan skid plate followed by tightening the two rear bolts until they achieve initial snugness and adding the two front bolts (if equipped) while securing them to 28 nm (21 lb ft). The oil pan skid plate must be installed on the 1500 series vehicles followed by tightening the oil pan skid plate bolts to the manufacturer specification of 28 nm (21 lb ft) if the vehicle comes with this component. Affix the engine shield to the frame before securing its bolts to 20 nm (15 lb ft) torque value. Finally, lower the vehicle.