Q: How to replace the engine coolant fan motor on Cadillac CTS?
A: The replacement process for the engine coolant Fan Motor begins with cooling fan assembly removal. Begin by removing the Fan Blade retaining nut attached to the motor after which you can extract the Fan Blade from the motor shaft. Then you need to remove the motor from the shroud by first unscrewing its retaining screws. Place the motor inside the shroud after positioning it properly and tighten the cooling Fan Motor retaining screws to 5 n.m (44 lb in). Put the Fan Blade on the motor shaft, let it fall naturally onto the shaft before you fasten the Fan Blade retaining nut to the motor with 7 n.m (62 lb in) torque. Install the cooling fan assembly when you have finished with all installation tasks.
Q: How to replace the Electric Cooling Fan Motor on Cadillac SRX?
A: Beginning the electric cooling Fan Motor replacement requires you to disconnect the cooling fan assembly. The first step involves removing the Fan Blade retaining nut attached to the motor as well as separating the Fan Blade from the motor shaft. To replace the motor start by removing its retaining screws then extract it from the shroud. Reset the motor within the shroud before securing the cooling Fan Motor retaining screws after tightening them to 5 nm (44 inch lbs.). Slowly drop the Fan Blade onto the rotating motor shaft by rotating the Fan Blade until it reaches the shaft position. Knot the Fan Blade retaining nut to the motor before tightening it to 7 nm (62 inch lbs.) then place back the cooling fan assembly.
Q: How to replace the Engine Coolant Fan Motor (LC3, LY7) (4.4L SC, 3.6L) on Cadillac STS?
A: The replacement process of the engine coolant Fan Motor (LC3, LY7) (4.4L SC, 3.6L) starts with removing the cooling fan assembly. Start by taking off the Fan Blade retaining nut from the motor before removing the Fan Blade from the motor shaft. You should start by taking the motor out of its shroud after removing its retaining screws. After placing the motor inside the shroud the installer must follow recommended fastener procedures. Insert the motor shaft into the Fan Blade before securing the cooling Fan Motor with proper tightening of retaining screws to 5 nm (44 lb in). The final step is to attach the Fan Blade retaining nut at 7 nm (62 lb in) to the motor before reinstalling the cooling fan assembly.