Q: How to replace the Headlight Switch (LHD) on Cadillac Seville?
A: The first step to replace a left-hand drive headlamp switch involves removing the left IP end cap. You should push on the back of the headlamp fog lamp switch assembly to free it from the removal position while disconnecting its electrical connectors. Proceed to connect the electrical wires associated with the new switch after taking out the headlamp switch. The headlamp fog lamp switch assembly should match the IP hole before being pushed into place for a flush mount. Reinstall the left IP end cap as the last step.
Q: How to service and repair the headlight switch on Cadillac Eldorado?
A: A thin instrument should be used between the instrument panel and the headlamp switch to carefully unhook the upper tabs on both sides of the headlamp switch knob while above the fog lamp switch because the soft cover on the panel can make removal challenging. The switch should first be detached from the instrument panel by depressing its lower tabs which will allow the removal of electrical connectors so you can remove the headlamp switch assembly. Connect the electrical connectors to the headlamp switch but install the headlamp switch assembly into the instrument panel opening by pressing evenly on all 4 corners to make it secure. Check that all skin locks connect with the instrument panel before proceeding.
Q: How to remove and install the Headlight Switch on a Cadillac DeVille?
A: Service of the headlamp/fog lamp switch assembly starts with removing the left IP end cap. Sliding force on the back side of the headlamp/foglamp switch assembly will help with removal while carefully disconnecting electrical connectors where needed. Use the electrical connectors to begin and properly position the headlamp, foglamp switch assembly through the IP opening by pressing it until it rests smoothly against the IP surface. Reinstall the left IP end cap as the last step of the installation process.