OEM Cadillac Seville Seat Cushion Pad

Cadillac Seville Seat Cushion Pad Parts and Q&A

• Seat Cushion Pad, Passenger Side
  16806428
  Q: How to replace the rear seat cushion pad on Cadillac Seville?

  A:

  First, press gently in and up on the front edge of the cushion, then lift it up and take it out of the seat. If your vehicle has heated seats, take off the connectors before taking out the cushion. For fitting the seat back, slide the cushion into place in the vehicle and hook up the heated seat wiring if your car has them. Make sure the two tabs on the cushion fit into the wire loops at the bottom of the seat back, then pull the front of the cushion up to make sure it's in place. At last, make sure you push the rear cushion down and backward onto the latches in the number four bar.
• Seat Back Pad, Front Passenger Side
  16806430
  Q: How to replace the front seat cushion pad on Cadillac Seville?

  A:

  When replacing the front seat cushion one must first disable the sir system. You should adjust the front seat assembly both upward and forward to reach fasteners located at the rear area of the front seat cushion assembly. Start by removing the fasteners located at the front seat cushion assembly rear. After that detach the assembly from the vehicle toward its back side. The front edge of the front seat cushion should be tilted upward to reveal the additional fasteners before they are extracted. After disconnecting the heated seat cushion electrical connector for ka1 models and ac9 adaptive lumbar air lines the mechanic should detach wire harness retainers from beneath the seat cushion framework. John prohn, a spokesperson for luther distributing inc., warns that the lumbar switch knob serves the lumbar switch assembly without any disassembly. Disconnect knobs (5,6) from the Seat Switch as well as the Seat Switch trim plate. You must pull the front seat cushion cover aside before you use the j 38778 door trim pad clip remover (J 38778) to take off the switch bracket retainers. Use the locking tab tools to detach the bracket holding the switches and bracket assembly from the bottom frame of the seat. The Seat Switch should be placed back onto the seat cushion frame before pulling the seat cushion cover over the switch maintaining hole alignment. Install the Seat Switch trim plate bezel by placing j channels on the seat cushion frame and then fasten the hoses and electrical wires together. Attach the knobs to the switch by reconnecting them to their respective holes. The heated seat functionality needs connection of its electrical connectors if added with ka1 along with adaptive lumbar air line adding on if using ac9. Both air components must attach to the seat frame. Secure the seat cushion assembly onto the seat riser after which install the front fasteners across the seat cushion assembly . Access the fasteners at the rear of the front seat cushion assembly by adjusting the front seat assembly upward and forward then install them while tightening them to 9 n.m (80 lb in). Tilt the front part of the front seat cushion to gain access to fasten the assembly together before tightening them to 9 n.m (80 lb in). Finally, enable the sir system.