To replace the sunroof sunshade cable assembly (front), first, open the sunshade fully remove the front sunroof window, then it goes through to the center window panel. Next, remove the front sunshade motor/actuator and the sunshade stop set-screw at the front of the track assembly. Remove the screws on the sunshade link to unhook it from the sunshade cable barrel and do away with the sunshade link in the sunshade channel carefully as it is always under tremendous hand. Push the cable assembly through the top side of the barrel using a flat-bladed tool while the barrel end is still inside the front track assembly of the sunroof window. Then, pull the cable longitudinally to get it out of the sunroof window front track assembly. For installation, attach the bullet end of the sunshade cable to the front part of the track assembly at the part where U-channel is using the cable until the barrel end is 25mm (1 in) away from the close part of the U-channel. Using a flat-bladed tool, push the cable through the channel until the barrel of the cable is about half straight path behind the rear end of the sunroof's track, viz, 32mm (1.25 in). Mount the sunshade stop set-screw flush with the front edge of the U-channel for the appropriate adjustment so that the sunshade operates as intended. Fold the sunshade one-half turn into the channel, then install the sunshade link into the channel and tighten with the sunshade screws to 2 N.m (18 lb in). Finally, install the front sunshade motor/actuator, center window panel, and front window panel and do the front sunshade initialization procedure.