To change the generator, remove the negative
Battery Cable and belt drive first. Next, detach the generator electrical connector and take off the generator cable by uncovering the terminal stud by sliding back the boot from the generator cable, removing the nut from the terminal stud and then taking off the generator cable. After, reversing the procedure done earlier, take out the generator bolts and remove the generator. For installation start by installing the generator, observing the fastener notice in service precautions. Assemble the bolts of the generator and tighten them up to 50 n.m (37 lb ft). Then, connect the generator cable to the generator by installing the cable, tightening the generator cable nut onto the terminal at 9 n.m (80 lb in) and accessing the boot over the terminal stud. Attach the generator electrical connector , re-attach the
Drive Belt and finally reconnect the negative Battery Cable.