OEM Chevrolet HHR Steering Angle Sensor

Chevrolet HHR Steering Angle Sensor Parts Questions & Experts Answers

• Angle Sensor
  15821965
  Q: How to center the steering angle sensor after specific service procedures on Chevrolet HHR?

  A: The Steering Angle Sensor needs infrequent centering but requires it after particular service procedures which include steering gear replacement, steering column replacement, Steering Angle Sensor replacement, intermediate shaft replacement, abs controller replacement or collision-related physical damage. Start by aligning front wheels forward through steering wheel operation then set the transmission to park position. To begin the procedure you need to install the diagnostic tool (Tool Required: scan tool). Connect a scan tool to the data link connector (DLC) then activate the Ignition Switch on while maintaining an engine off state. Direct the scan tool to select chassis/ebcm control system vehicle stability enhancement system (VSES) and special function test followed by steering pos. Sensor calibration. The scan tool provides instructions to perform automated centering where users must turn the wheel first left 5 degrees then right 5 degrees and finally straight ahead. Disable any detected dtcs through clearing procedures before continuing with a diagnostic system check to ensure all dtcs remain cleared. All Steering Angle Sensor centering is finished.