Before replacing the Steering Wheel users should disable sir system functions and turn the ignition to off. Take out the inflatable restraint Steering Wheel module before drawing an alignment mark on the Steering Wheel hub which should match up with the slash mark on the
Steering Shaft. Set the Steering Wheel nut to meet the end of the Steering Shaft and position it properly. You can remove the Steering Wheel from its Steering Shaft by using the j 1859-a (Steering Wheel Puller) assembled with the j 42578 (Steering Wheel Puller Legs). The sir connector needs to be unrousted from the Steering Wheel before you can take it out of the vehicle. When installing the new Steering Wheel fit it onto the
Steering Column and direct the sir connector through the opening afterward use the scribe mark to line up with the slash mark on the Steering Shaft. Put the Steering Wheel in its place while securing the Steering Shaft nut at 45 nm (33 ft. Lbs.). Steering Wheel module from inflatables reinstallation leads to sir system activation. Conclude by checking the
Horn functionality along with examining Steering Wheel operation and the controls on the Steering Wheel.