OEM Chevrolet Metro Brake Pad

Chevrolet Metro Brake Pad Parts Questions & Experts Answers

• Brake Pads
  91173482
  Q: How to replace the brake pads on Chevrolet Metro?

  A: Start brake pad replacement by draining two-thirds of the fluid from the master cylinder reservoir. Raise your vehicle at its specified points before taking off the tire and wheel setup. Position the C-clamp over the outer pad and caliper units while tightening it for the piston to reach its bore's lowest possible position. Disconnect the caliper from the carrier by taking out the two mounting bolts and hang it with wire to shield the brake hose. Pull out the pads from their resting position on the caliper carrier. Also take off the caliper dampener clips from their attachment points on the caliper carrier. Begin the installation process by putting on two caliper dampener clips to the caliper carrier before setting the pads onto its surface. Apply silicone grease to the caliper pins before inserting both pins with their boots into the caliper carrier but keep to the Fastener Notice in Service Precautions. Mount the caliper to the caliper holder with two bolts by turning them to 30 Nm (22 foot pounds). Put back the wheel unit while filling hydraulics into the reservoir.