To replace the (K43) 102 ampere generator have to disconnect the negative
Battery Cable and remove the engine compartment cross vehicle brace. Then, remove the
Drive Belt from the coil of the generator and set the coolant recovery reservoir to one side so that it is accessible. On bolts (1,2,3), from the generator, disconnect the electric connector and lay aside the protective boot on the output bat terminal of the generator. Remove the bat terminal nut from the generator output then unplug the positive battery lead from the generator prior to removing the generator. For installation, install the generator into the engine then attach positive battery lead and the generator output bat terminal nut, tighten the nut to 20n.m (15lb ft). Cover the protective boot on the generator output bat terminal, connect the electrical connector to the boots, and install generator bolts (2,3),then generator pivot bolt and generator rear brace nut. Tighten the generator bolts, ut in the order of: tighten the generator pivot bolt to 50 n.m (37 lb ft), the generator bolt to 50 n.m (37 lb ft), and the nut to 25 n.m (18 lb ft). Finally, put back the engine compartment cross brace, the Drive Belt and the coolant recovery reservoir, reattach the negative cable from the battery.