Other Name: Switch Assembly, Turn Signal & Headlamp Dimmer, Wiper & Washer (W/Lever); Multi Purpose Combination Switch; Turn/Wiper Lever; Switch, Windshield Wiper Control; Switch, Turn Signal Lamp; Switch, Headlamp Dimmer
Replaces: 26093873, 26073612, 26085930
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2000-2005 Chevrolet Monte Carlo | LS, LS Competition, LS Sport, LT, SS, SS 35th Anniversary Edition, SS Dale Earnhardt Signature Edition, SS High Sport, SS Pace Car | 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
Other Name: Switch Assembly, Turn Signal & Headlamp Dimmer, Wiper & Washer (W/Lever); Multi Purpose Combination Switch; Turn/Wiper Lever; Switch, Windshield Wiper Control; Switch, Turn Signal Lamp; Switch, Headlamp Dimmer
Replaces: 26073613, 26093874, 26085931
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2000-2005 Chevrolet Monte Carlo | LS, LS Competition, LS Sport, LT, SS, SS 35th Anniversary Edition, SS Dale Earnhardt Signature Edition, SS High Sport, SS Pace Car | 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
Other Name: Switch, Turn Signal; Multi Purpose Switch; Turn Signal; Signal Switch; Switch; Switch, Turn Signal Lamp
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1995-1999 Chevrolet Monte Carlo | LS, Z34 | 6 Cyl 3.1 L GAS, 6 Cyl 3.4 L GAS, 6 Cyl 3.8 L GAS
Chevrolet Monte Carlo Turn Signal Switch
Our website offers an extensive catalog of genuine Chevrolet Monte Carlo Turn Signal Switch at unbeatable prices. Every OEM Chevrolet Monte Carlo Turn Signal Switch comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Monte Carlo Turn Signal Switch Parts Questions & Experts Answers
Q: How to replace the Turn Signal Switch on Chevrolet Monte Carlo?
A: Start by disabling the SIR system as explained in the Service Precautions section before replacing the multifunction turn signal lever of the vehicle. Detach the wire harness assembly from its mounting strap while taking note of its connector outlet in the abrasion sleeve. Unplug the turn signal and multifunction switch assembly at both ends from the SIR system coil connector and let its 2 endcaps fall out of the grounded housing. Take off both pan head tapping screws from the turn signal/multifunction switch and pull the assembly out of the steering column tilt head. Fasten the turn signal and multifunction switch assembly onto the steering column tilt head assembly with the provided 2 pan head tapping screws . Tighten the top screw to 3 N.m (30 lb in) and the side screw to 7 N.m (62 lb in). Push both ends of the turn signal and multifunction switch assembly connectors into the bulkhead interface then link the switch assembly to the SIR coil connector. Place the wire harness assembly back into its strap after making sure the abrasion sleeve fits correctly on the steering column harness. Let the ignition lock cylinder case wires and electrical connector extend through the middle opening. Reapply both trim sections and activate the SIR system.