OEM 2002 Chevrolet Malibu Throttle Cable

2002 Chevrolet Malibu Throttle Cable Parts and Q&A

• Q: How to replace the throttle cable on 2002 Chevrolet Malibu?

  A: Replace the throttle cable by starting by turning OFF the ignition followed by removing the left instrument panel sound insulator. Move the throttle pedal cable toward the bulkhead by pulling it from the speed control pedal and folding the throttle cable cover tangs. Start by removing the throttle cable shield when present before disconnecting the cable from both the retaining clip and throttle body lever and throttle cable bracket. Note down how the cable routes itself when you pull the throttle cable out from the vehicle. During installation route flexible parts at least 50 mm (2 in) away from wheel motion except if properly fastened for interference prevention. Follow the specified routing when you install the throttle cable before installing the snap retainer through the bulkhead. The throttle cable should be inserted into the slot of the throttle pedal lever while properly seating the snap retainer. After routing the throttle cable to the throttle body lever and throttle cable bracket users should attach it to the retaining clip. Inspect throttle operation from full open to closed positions by operating the pedal while also checking that the carpet does not interfere with the pedal operation. Lastly, check that the throttle works without constraint between its extreme positions before you install the left instrument panel sound insulator.