OEM 2006 Chevrolet Monte Carlo Rocker Shaft Spring Kit

2006 Chevrolet Monte Carlo Rocker Shaft Spring Kit Parts and Q&A

• Q: How to replace the Rocker Shaft Spring Kit and valve stem oil seal on 2006 Chevrolet Monte Carlo?

  A: In order to replace the Valve Stem Oil Seal and valve spring, firstly, the valve Rocker Arm has to be removed. Make sure the engine has warmed up enough before loosen the spark plugs 1 or 2 turn and clean the surrounding area from dirt. Unplug the spark plugs and press the Spark Plug port adapter (J22794) into the hole of the spark plugs, connect the Air Hose to the j22794, and use a supply of compressed air to activate the valves. Compress the valve spring using a valve spring compressor j38606 and loosen valve stem keys (225) and carefully release valve spring tension with j38606. Once you remove the j38606, remove valve spring cap (224), valve spring (223), and Valve Stem Oil Seal (222). Clean the cylinder head valve spring seat and area prior to installing the new Valve Stem Oil Seal (222), valve spring (223), and value spring cap (224). Compress valve spring using the j38606 and install the valve stem keys, and grease is supposed to hold them in a firm posture in the groove of the valve stem. Carefully reduce valve spring tension with the j38606, remove, and tap the end of the valve stem the plastic-faced hammer with valve stem keys if necessary. After disconnecting the compressed air supply from the j22794, remove it out from the Spark Plug port. Hand crank the Spark Plug and tighten it to 15 nm (11 ft. Lbs.), and reinstall the valve Rocker Arm.