OEM 2008 Chevrolet Corvette ABS Control Module

2008 Chevrolet Corvette Parts Questions & Experts Answers

• Q: How to replace the ABS Control Module on 2008 Chevrolet Corvette?

  A: A proper replacement process for the ABS Control Module requires the ignition switch to be set to off before disconnecting the negative Battery Cable to protect both ABS Control Module and ebtcm units. The high-speed lan control modules need at least 2 minutes until they de-activate after turning the ignition off. Remove the negative Battery Cable while you clean away all dirt and contaminants from both the ABS Control Module device and brake pressure modulator valve (BPMV). To obtain better ABS Control Module connector access you should raise the vehicle and detach the two mounting bolts that secure the bpmv bracket to the crossmember. The abs modulator assembly needs support while you disconnect the electrical connector from the brake fluid pressure sensor after releasing the connector cam. Individuals should use caution while removing the 4 ABS Control Module-to-bpmv retaining bolts to separate the ABS Control Module from the bpmv. The sealing surface on bpmv needs denatured alcohol cleaning before installing the ABS Control Module with its motor connector properly connected. Feed the ABS Control Module to the bpmv terminal positions before tightening its four retaining bolts in a criss-cross pattern to 5 n.m (44 lb in). You can reinstall the ABS Control Module and brake fluid pressure sensor electrical connectors while installing the two bpmv bracket-to-crossmember mounting bolts which should be tightened to 27 n.m (20 lb ft). Finish by lowering the car and then restore the negative Battery Cable connection. Program the new module after installation and execute the diagnostic system check - vehicle.