Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2010-2016 Buick LaCrosse | Base, Convenience, CX, CXL, CXS, Leather, Premium, Sport Touring, Touring | 4 Cyl 2.4 L GAS, 4 Cyl 2.4 L MILD HYBRID EV-GAS (MHEV), 6 Cyl 3.0 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
Buick LaCrosse Door Hinge
Our website offers an extensive catalog of genuine Buick LaCrosse Door Hinge at unbeatable prices. Every OEM Buick LaCrosse Door Hinge comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Buick LaCrosse Door Hinge Parts Questions & Experts Answers
Q: How to replace the rear side door hinge on Buick LaCrosse?
A: Before replacing the rear side door hinge users must tape the door edge with masking tape to stop paint damage. The door should stay connected to its vehicle throughout the procedure. You can reach the rear door hinges through the front door door without having to open the rear door. Mark the hinge area using grease marker after cleaning it. Causation of upper hinge breakage necessitates bolt removal starting with numbers (1 and 4) from the door side before proceeding to the same sequence at the hinge pillar side. The process of removing a lower hinge begins by removing door side bolts in sequence (3, 2) followed by the bolts from the hinge pillar side in the same order until the damaged hinge is removed. The new hinge requires positioning following the alignment marks found on the hinge pillar and door side. These steps must be followed to put the lower hinge bolts into the hinge pillar side in order (3, 2) and tighten them to 33 N.m (24 lb ft). The process is completed by adding the lower hinge bolts to the door side in the same sequence and tightening them to 33 N.m (24 lb ft). You should start by putting the upper hinge bolts to the hinge pillar side according to the sequence (1, 4) then tightening them to 33 N.m (24 lb ft). Proceed by doing the same to the upper hinge bolts to the door side in the same sequence and tighten them to 33 N.m (24 lb ft). To complete the installation you must first take away the support from the door before doing a proper operation check and removing the masking tape.