To replace the Starter motor, one should first disconnect the negative Battery Cable. Next, disconnect the left Catalytic Converter, then the Starter heat shield bolt and shield. Then remove the Starter solenoid bat terminal nut and the battery positive junction block cable terminal from the Starter. Loosen the Starter bolts and pull out the Starter from the engine, disconnecting the engine wiring harness electrical connector. For installation, install the Starter and fasten it with bolts and tighten bolts to 50 n.m (37 lb ft). Connect the engine wiring harness electrical connector to the Starter and connect the battery positive junction block cable terminal to the Starter. Install the bat terminal nut of the Starter solenoid and tighten it to 25 n.m (18 lb ft). Next, install Starter heat shield and bolt, tighten bolt to 7 n.m (62 lb in), then the left Catalytic Converter. Finally, reconnect the negative Battery Cable.