Century | 1987-1994 | Custom, Estate Wagon, Limited, Special | 4 Cyl 2.2 L GAS, 4 Cyl 2.5 L GAS, 6 Cyl 2.8 L GAS, 6 Cyl 3.1 L GAS, 6 Cyl 3.3 L GAS, 6 Cyl 3.8 L GAS
Q: How to replace the washer reservoir on Buick LaCrosse?
A: Start by opening the hood and letting washer solvent flow out from the container. Twist the upper washer solvent container screw and take out the right front fender liner from beneath. Disconnect the Washer Pump hose then take off the Washer Pump's electrical plugs and level sensor's electrical wire. Unplug the Washer Pump and level sensor first then remove the washer solvent container screws from both ends before withdrawing it from the right frame rail. Install the washer solvent container onto the right frame rail first and screw on its lower parts before tightening them to 10 n.m (89 lb in). Replace the Washer Pump and level sensor onto the container before connecting the washer solvent level sensor electrical plug and the Washer Pump electrical outlet as well as the hose. Place the right front fender liner and the upper container screw together and fasten them to 10 n.m (89 lb in). Place washer solvent into the solvent container before securing the hood.
Q: How to Service and Repair the Washer Reservoir on Buick LeSabre?
A: To replace the Washer Reservoir you should detach the right front fascia and disconnect washer connections from the Washer Pump and washer level sensor. Unfasten three reservoir mounting nuts and take out the Washer Reservoir from the vehicle after removing its pump part. First locate the Washer Pump and pick it up to slot it back into the Washer Reservoir. Place the assembly onto the vehicle and thread the 3 nuts tightly to 6 n.m (53 lb in). Realign the electrical wires one by one in this order: washer level sensor, Washer Pump connector, and Washer Pump. Then connect the washer hose to the Washer Pump before you put back the right side front panel.
Q: How to replace the washer reservoir on Buick Regal?
A: Twist out the screw from the upper tube assembly before you take off both its components and the seal. Start by detaching the right headlamp assembly along with the front Washer Reservoir screw. Then take out the front fender liner. You need to pull out the Washer Reservoir by taking off two screws after disconnection of electrical components and the hose from Washer Pump. Pull off the hose and electrical connector from the Washer Reservoir level sensor and take out the Washer Reservoir. Loosen the two holder screws and remove the Washer Reservoir bracket before taking off the Washer Reservoir level sensor and seal. Continue by removing the Washer Pump and its seal. First connect the washer pumps and seals and then fit the reservoir level sensor with its seal into place. Secure the bracket on the Washer Reservoir with two screws before tightening them to 7 n.m (62 lb in). Secure the Washer Reservoir level sensor with its electrical connector before mounting the Washer Reservoir over the vehicle. Fit the two mounting screws and torque them to 10 n.m (88 lb in). Put the Washer Pump electrical connector and hose together, put the front Washer Reservoir screw in place and tighten it to 5 n.m (44 lb in), and then install the front fender liner with the right headlamp assembly before securing the upper tube assembly and seal of the Washer Reservoir using a screw tightened to 10 n.m (88 lb in).