Other Name: Control Assembly-Heater & A/C User Interface; Climate Control Module; Blower Control Switch; HVAC Control Module; Dash Control Unit; Control, Heater And A/C Control
Replaces: 84264177, 84214109, 84264174
Fits the following Cadillac Models:
CT6 | 2016-2020 | Base, Luxury, Platinum, Plug-In, Premium Luxury, Sport, V | 4 Cyl 2.0 L GAS, 4 Cyl 2.0 L PLUG-IN HYBRID EV-GAS (PHEV), 6 Cyl 3.0 L GAS, 6 Cyl 3.6 L GAS, 8 Cyl 4.2 L GAS
Other Name: Control Assembly-Heater & A/C (W/Front Seat Heater; Climate Control Module; Blower Control Switch; Dash Control Unit; Control, A/C Instrument Panel
Position: Front
Replaces: 20921719
Fits the following Cadillac Models:
Escalade | 2012-2013 | Hybrid, Hybrid Platinum | 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV)
Other Name: Control Assembly-Heater & A/C (W/Front Seat Heater; Climate Control Module; Blower Control Switch; Dash Control Unit; Control, A/C Instrument Panel
Position: Front
Fits the following Cadillac Models:
Escalade | 2009-2011 | Hybrid, Hybrid Platinum | 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV)
| Page 1 of 10 |Next >
1-20 of 188 Results
Cadillac Blower Control Switches Parts Questions & Experts Answers
Q: How to Service and Repair Blower Control Switches on Cadillac Eldorado?
A: Lift the blower switch knob off by using a flat bladed tool with care. After that, gently take off the rear trim plate from the console and unscrew the screws that fasten the rear blower switch. Take off the electrical connector and take out the rear blower switch. First, attach the electrical connector to the rear blower switch, then place the switch onto the trim plate and hold it in place with the screws. After that, put the rear console trim plate back on.
Q: How to replace the Blower Control Switches for the Auxiliary (Front) Blower Motor on Cadillac SRX?
A: To fix the auxiliary (Front) blower motor switch use light pressure to pull down the front side of the overhead console until its fasteners come loose and remove it. The process begins by disconnecting the blower motor switch electric wire and dome lamp electric wires. Afterward, remove the screws to take out the blower motor switch from its position in the dome lamp housing. Secure the blower motor switch into the dome lamp housing then fasten its screws and tighten them to 1 n.m (9 lb in). First connect both the blower motor switch and dome lamp electrical connectors and then replace the overhead console.