Other Name: Motor Kit, Air Conditioner Evaporator Blower; HVAC Blower Motor; Blower Assembly; Motor Assembly; Motor, A/C Evaporator Blower; Motor, Heater Blower Motor
Q: How to replace the blower motor in a right-hand drive on Cadillac CTS?
A: Start your right-hand drive blower motor replacement by removing the left insulator panel. Next you need to disconnect the instrument panel (I/P) compartment. Twist the I/P mounting bolts only slightly from their position and move the I/P carrier left and right to open up room for motor removal. Remove the power connection from both the blower motor and the blower motor processor. Unscrew the screws which support the blower motor and pull out the motor as a single unit. Put the blower motor into its correct position and install two blower motor screws. Tighten these screws to 1.5 Nm torque (13 pound inch). Connect both the blower motor electrical plug and processor electrical panel. Insert and lock the I/P compartment before placing the left insulator panel. Secure the I/P carrier bolts and thread them to 25 Newton meters or 19 pound feet of torque.
Q: How to replace the auxiliary blower motor on Cadillac SRX?
A: The first step of changing the Auxiliary Blower Motor involves removing the left body side trim access panel. Unplug the blower motor electrical connection followed by removing two screws that attach the blower motor to the HVAC module before extracting the blower motor from its position. Realign the blower motor into the HVAC module before securing it according to the specified warnings in the Fastener Notice. Reinstall the left body side trim access panel after connecting the auxiliary blower motor electrical connector and securing the motor with screws at 1 N.m (9 lb in).
Q: How to replace the blower motor on Cadillac XLR?
A: You must remove the rh insulator panel before starting work on the Blower Motor. Disconnecting power will prevent the Blower Motor from starting accidentally if you touch it to the ground since this action could harm you. Detach the Blower Motor electrical connector before extracting its retaining screws and removing the Blower Motor from the hvac appliance. Put the new Blower Motor into the hvac unit while keeping these important safety steps in mind. Reattach the electrical connector and return the rh insulator panel once you have placed the retaining screws firmly at 1.6 nm (14 lb in).