Other Name: Relay, Air Suspension And Inflator Unit; Multi Purpose Relay; Relay, Engine Air Cooling; Emission Control System; Voltage And Glow Plug; Rear Window Defogger
Fits the following Cadillac Models:
DeVille | 2000-2005 | Base, DHS, DTS, Protection Series | 8 Cyl 4.6 L GAS
Other Name: Relay, Headlamp/Fog Lamp/Turn Signal; Multi Purpose Relay; Relay: Trans Oil Pump, Eng Air Cooling(Elec), Headlamp Washer/Wiper, Voltage & Glow Plug, Eng Vacuum Pump, Starter Motor
Replaces: 13500119
Fits the following Cadillac Models:
ATS | 2015-2017 | Base, Luxury, Performance, Premium, Premium Luxury, Premium Performance, V | 4 Cyl 2.0 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
XT5 | 2017-2018 | Base, Luxury, Platinum, Premium Luxury | 6 Cyl 3.6 L GAS
Other Name: Relay Assembly-Electrical Door Lock; Multi Purpose Relay; Actuator Relay; Door Electric And Vacuum Locks; End Gate Electrical; Front Seat Lumbar; Body Wiring
Fits the following Cadillac Models:
Seville | 1986-1988 | Base, Elegante, STS | 8 Cyl 4.1 L GAS, 8 Cyl 4.5 L GAS
Q: How to replace the reverse lamp relay on Cadillac Eldorado?
A: Begin by removing the rear seat back before removing the cover from the number 4 relay center to access the reverse lamp relay. Place the new reverse lamp relay into number 4 relay center after fitting the relay center cover and restoring the rear seat back.
Q: How to replace the Power Distribution Relay attached to the wire harness on Cadillac XLR?
A: The first step to replace a Power Distribution Relay which connects to the wire harness begins with using the Master Electrical Component List to identify its location in the vehicle. The following steps should be used for relay replacement beginning with fastener removal before extracting CPA devices and secondary locks while paying attention to avoid damaging the relay while disconnecting it from the wiring harness. Reconnect the new relay to its wire harness connector after separating it then reinstall CPA devices and secondary locks followed by replacing original fasteners and tape for securing the relay.
Q: How to replace the Power Distribution Relay attached to the wire harness on Cadillac CTS?
A: Replacing the Power Distribution Relay on the wire harness means you should find it with the help of the Master Electrical Component List first. First, take off all fasteners holding the relay, and be sure to take off any CPA devices or secondary locks. Pull the relay gently away from the wire harness connector . During installation, attach the relay back to the wire harness connector , put any CPA devices or secondary locks in place, and fasten the relay using its original mounts or tape.