Other Name: Sensor, A/C; Air Charge Temperature Sensor; Intake Air Temperature Sensor; Air Temperature Sensor; Air Intake Temperature Sensor; Computer Control Sensors; Air Cleaner Controls; Intake Sensor
Other Name: Sensor Package; Air Charge Temperature Sensor; Intake Air Temperature Sensor; Air Intake Temperature Sensor; Air Cleaner Controls; Air Cleaner Intake; Sensor.
Fits the following Cadillac Models:
Seville | 1986-1987 | Base, Elegante | 8 Cyl 4.1 L GAS
Other Name: Sensor, Air Cleaner; Air Charge Temperature Sensor; Intake Air Temperature Sensor; Air Temperature Sensor; Air Intake Temperature Sensor; Vacuum Valve; Air Cleaner Controls; Intake Sensor; Intake Valve
Fits the following Cadillac Models:
Fleetwood | 1993 | Base, Brougham | 8 Cyl 5.7 L GAS
Q: How to replace the Mass Air Flow Sensor/intake air temperature sensor on Cadillac CTS?
A: Start by turning off the ignition to begin replacing the Mass Air Flow Sensor/intake Air Temperature Sensor. You should disconnect the Mass Air Flow Sensor (MAF) electrical connector as the first step. Because preliminary steps require removing the air cleaner intake duct and then the Mass Air Flow Sensor fasteners respectively. First place the Mass Air Flow Sensor and Mass Air Flow Sensor seal in a new position before discarding the original seal. Start with installing the new Mass Air Flow Sensor seal and the Mass Air Flow Sensor into their designated positions. Secure the Mass Air Flow Sensor using its screws and apply 4 n.m (35 lb in) of torque force. Replace the air cleaner intake duct and restore the connection of the Mass Air Flow Sensor electrical connector.
Q: How to replace the Mass Air Flow Sensor/intake air temperature sensor on Cadillac Escalade?
A: When replacing the Mass Air Flow Sensor and intake Air Temperature Sensor maintain careful handling of the Mass Air Flow Sensor/iat sensor to protect its honeycell at the air inlet end and refraining from contacting the sensing elements and exposing them to cleaning solvents or lubricants. A little non-silicone lubricant should be applied to the air duct for easier installation. The first step involves disconnecting the engine wiring harness electrical connector from the Mass Air Flow Sensor/iat sensor then proceeding to loosen the Mass Air Flow Sensor/iat sensor adapter clamp before removing the sensor from the air cleaner assembly. The installation of a new Mass Air Flow Sensor/iat sensor needs complete alignment of the embossed arrow marking to direct airflow toward the engine. Insert the sensor into the air cleaner assembly while fastening the Mass Air Flow Sensor/iat sensor adapter clamp to 4 n.m (35 lb in) torque and then reattach the engine wiring harness electrical connector to the Mass Air Flow Sensor/iat sensor.
Q: How to replace the Mass Air Flow Sensor/intake air temperature sensor on Cadillac XLR?
A: As the first step in replacing the Mass Air Flow Sensor/intake Air Temperature Sensor you need to remove the air cleaner assembly. You should start by removing the air cleaner resonator duct after you loosen its clamp. Start by removing the bolts that secure the Mass Air Flow Sensor/intake air temperature (IAT) sensor then pull out the sensor while also taking its seal. To perform the installation first position the new Mass Air Flow Sensor/iat sensor and its replacement seal while observing recommended fastener recommendations. Before tightening, install both Mass Air Flow Sensor/iat sensor bolts while keeping torque at 4 n.m (35 lb in). Reinstall the air cleaner resonator duct before tightening its clamp while completing the replacement of the air cleaner assembly.