Q: How to Service and Repair the Turn Signal Flasher on Cadillac CTS?
A: You must take out the driver side I/P cover to gain access to the flasher module. Disassemble the module from its holder on the I/P carrier and disconnect the wire plug. Place the electrical connector to the flasher module then apply the retaining clip to the I/P carrier before putting back the driver side I/P closeout/Insulator panel.
Q: How to service and repair the Turn Signal Flasher on a Cadillac DeVille?
A: You must first remove the left knee bolster to reach the turn/hazard flasher area. Today you need to pull out the flasher unit and disconnect the electrical connector. Plug in the electrical connector before adding the turn/hazard flasher module then put back the left knee bolster.
Q: How to Remove and Install the Turn Signal Flasher on Cadillac Eldorado?
A: For the turn signal flasher servicing, remove the left closeout/insulator panel first. Second, pull off the turn signal flasher from the upper instrument panel carrier assembly and turn off its electrical connector prior to removing the turn signal flasher. For installation, plug the electrical connector to the turn signal flasher and insert into the slot of the instrument panel carrier assembly. Slide the flasher upward to hold the retainer clip for the carrier assembly, and finally re fixture the left closeout/ insulator panel.