Other Name: Sensor, Front Wheel Speed; ABS Wheel Speed Sensor; ABS Speed Sensor; Speed Sensor; Trim Panel; Front Speed Sensor; Sensor, Electronic Brake Control
Position: Front
Replaced by: 84356646
Fits the following Cadillac Models:
Escalade | 2002-2006 | Base | 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
Q: How to replace the front wheel speed sensor (AWD) on Cadillac CTS?
A: Begin your front Wheel Speed Sensor replacement process by lifting and supporting your vehicle under it. Proceed to take off the wheel and tire combination from the vehicle. Unplug the Wheel Speed Sensor electrical connector and take off all wire harness clips from the stabilizer bar bracket and Steering Knuckle as well as from the bracket. Thoroughly clean the space around the Wheel Speed Sensor on the Steering Knuckle before beginning work. Take out the Wheel Speed Sensor by first unscrewing the bolt from the Steering Knuckle. Place the new speed sensor wheel onto the Steering Knuckle then slot and secure the Wheel Speed Sensor bolt with 9 nm (80 lb in) force. Fasten the Wheel Speed Sensor wire harness clip back onto the Steering Knuckle before connecting the Wheel Speed Sensor electrical connector return the tire and wheel assembly before fastening the Wheel Speed Sensor wire harness clips onto the stabilizer bar bracket.
Q: How to replace the rear wheel speed sensor and ensure its proper functioning on Cadillac Escalade?
A: Start the replacement process by lifting up your vehicle and putting it in a stable position. Unplug the power source and take out the wheel speed sensor bolt. Detach the wheel speed sensor wiring clips from their retainers before taking out the wheel speed sensor. Turn the wheel speed sensor clockwise until it reaches full insertion then install and tighten its bolt to 13 N.m at 115 lb inch torque setting. Plug in the electrical connector and route the wheel speed sensor wiring harness to its retainers before letting the vehicle down to the ground. Start the engine and let it run to test the wheel speed sensor using the ABS or traction assist light for verification. Drive the vehicle only after professional diagnosis and wheel speed sensor connector assessment. Check Symptoms of Antilock Brake System problems when the warning lamp stays lit. Choose a straight area without debris or traffic and drive the vehicle steadily at 16 km/h (10 mph) or more for 5 seconds. When done check if the ABS or traction assist indicator appears; call Diagnostic Starting Point - Antilock Brake System for help.
Q: How to replace the front wheel speed sensor on Cadillac SRX?
A: Starting the job requires lifting the vehicle and taking out the tire and wheel assembly. Thoroughly wipe the mount area of the suspension knuckle where the Wheel Speed Sensor connects. To access the Wheel Speed Sensor first take off the sensor bolt and disconnect both electric and mechanical connections to the Steering Knuckle. Take the Wheel Speed Sensor directly out from the Steering Knuckle. After attaching the Wheel Speed Sensor electrical connector to the Steering Knuckle ensure it is properly fastened before inserting the Wheel Speed Sensor into the knuckle. Connect the Wheel Speed Sensor bolt with 9 nm force (80 lb in torque). Reassemble the tire and wheel then run the diagnostic system check for vehicle.