Q: Are the window channels serviced separately from the window regulator, and what tools and procedures are required for replacing the front side door window regulator on Cadillac CTS?
A: The window channels cannot be serviced independently of the window regulator and the front side door window regulator should be changed with the help of the above tools and instructions.
Q: How to replace the window channel in the door on Cadillac Eldorado?
A: Begin your replacement task by taking out the trim panel with the water deflector, sealing strip, and window. First undo the front upstop adjuster nut and part then remove the bolt while being cautious not to harm the seal here. Turn the top of the front run channel away from the mirror and push it toward the bottom of the door until it detaches from the retainer. After that pull up the bottom end of the channel to get it out. To install place the front run channel parallel to the bottom of the door and insert it from the inside. Then position the lower adjuster into the retainer before pushing the top of the channel up. Set the retainer next to the bolt hole and fasten the bolt by tightening it to 11 N.m (97 lb in). Apply upstop adjuster first then place the nut and tighten it to 9 N.m (80 lb in) force. Put a small amount of GM P/N 99882386 or equal lubricant on the channels without using it on the door window or belt line sealing strips. Put the window in place and make needed adjustments before adding the sealing system components which include the sealing strip water deflector and trim panel.
Q: How to replace the rear door front window channel on Cadillac DeVille?
A: Starting the replacement of rear door front Window Channel requires removal of the door trim panel first. You should first remove the door module as well as the water deflector. Reconnect the Power Window Switch along with the module after which raise the window all the way to its maximum height level. Start by taking off the upper and lower fasteners from the front Window Channel then turn it forward before pulling it out through the front opening of the inner door panel. Insert the new front Window Channel through the same opening hole then reverse it while you position it at the bottom of the window. Fasten the front Window Channel fasteners along both top and bottom using torque of 9 n.m (80 lb in). After lowering the window to its maximum position disconnect the Power Window Switch and module then reinsert the water deflector before reinstalling them. To conclude the installation process both the door module and door trim panel need to be put into place.