OEM Chevrolet Camaro Cruise Control Module

Chevrolet Camaro Cruise Control Module Parts Questions & Experts Answers

• Control Module
  25315091
  Q: How to replace the cruise control module on Chevrolet Camaro?

  A: Start by rotating the throttle lever to the rear position followed by pushing down the cable end from the throttle lever pin and pushing a flat bladed tool into the Throttle Body bracket retainer to disengage the cruise control cable from under the accelerator and cruise control cable servo bracket. Vehicles without traction control require this procedure first. Start by removing the servo cable adjuster cover when traction control is present through upper cam rotation and locking tab unsnap followed by cable removal from the slot. Before installation secure the Throttle Body end of the cruise control cable near the Cruise Control Module then maintain the vehicle in the raised position and detach the left front bumper fascia lower deflector. Start by removing the rotation point bracket bolts then extract the Cruise Control Module and bracket from left side engine compartment outer rail. Unsnap the Cruise Control Module cover followed by removing the electrical connector retainer to disconnect the Cruise Control Module electrical connector. Extract the cable locking retainer from the module then compress its conduit tangs to free the cruise control cable through the module as the cable bead detaches from the ribbon inside the module. Place the module-bracket pair on a work surface while you remove the Cruise Control Module brackets then detach the module from its bracket. Put the Cruise Control Module onto the bracket before installing its bolts with 5 n.m (44 lb in) torque. Initiate cable end inspection to confirm o-ring placement then pull Throttle Body cable tension until it is taut before connecting the cable bead to the module ribbon and rotating the cable end as needed to straighten the ribbon before pushing the cable fitting over the ribbon and snapping the module connection while confirming conduit tang alignment. You must first install the cable locking retainer onto the module before connecting the Cruise Control Module electrical connector along with its retainer. Route the Cruise Control Module cover over the bracket and cable before snapping the bracket flanges closed to install the Cruise Control Module against left side engine compartment outer rail. Then tighten the Cruise Control Module bracket bolts to 10 n.m (89 lb in) and the Cruise Control Module bracket bolt to 2 n.m (18 lb in). After installing the left front bumper fascia deflector, raise the vehicle back up then route the Throttle Body cable to its destination. Install the circuit control cable slug to the servo adjuster but first install the upper cam. Guide the cable into the slot with caution to verify the locking tab latches while lowering the servo cover onto its place. Installation of the cruise control cable without traction control requires you to first rotate the throttle lever toward the rear before snapping its end to the throttle lever and sliding the cable onto the correct slot with the locking tab secured.