Other Name: Actuator Assembly-Front Seat Adjuster Vertical; Motor; Actuator; Actuator, Front Seat Adjuster
Position: Front Driver Side
Replaces: 13279131
Fits the following Chevrolet Models:
Cruze | 2011-2015 | Diesel, Eco, L, LS, LT, LTZ | 4 Cyl 1.4 L GAS, 4 Cyl 1.8 L FLEX, 4 Cyl 1.8 L GAS, 4 Cyl 2.0 L DIESEL
Cruze Limited | 2016 | Eco, L, LS, LT, LTZ | 4 Cyl 1.4 L GAS, 4 Cyl 1.8 L FLEX, 4 Cyl 1.8 L GAS
Equinox | 2010-2017 | L, LS, LT, LTZ, Premier | 4 Cyl 2.4 L FLEX, 4 Cyl 2.4 L GAS, 6 Cyl 3.0 L FLEX, 6 Cyl 3.0 L GAS, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
Impala | 2014-2020 | Eco, LS, LT, LTZ, Premier | 4 Cyl 2.4 L MILD HYBRID EV-GAS (MHEV), 4 Cyl 2.5 L FLEX, 4 Cyl 2.5 L GAS, 6 Cyl 3.6 L BI-FUEL, 6 Cyl 3.6 L FLEX, 6 Cyl 3.6 L GAS
Malibu | 2013-2015 | Eco, LS, LT, LTZ | 4 Cyl 2.0 L GAS, 4 Cyl 2.4 L MILD HYBRID EV-GAS (MHEV), 4 Cyl 2.5 L GAS
Malibu Limited | 2016 | LS, LT, LTZ | 4 Cyl 2.5 L GAS
Q: How to Replace the Seat Motor in a Power Seat on Chevrolet Classic?
A: Begin the horizontal actuator replacement process after positioning the front seat to its highest vertical slot which reveals the bolts on the horizontal actuator. Take out the front seat before continuing the replacement of the vehicle's horizontal actuator. The motor support bracket becomes removable before proceeding when the actuator is situated next to the horizontal motor. The oblong connector on the horizontal actuator requires equalization before you can remove the bolts which secure the horizontal actuator. You should remove the actuator from its position in the upper channel. Put the actuator once again into the upper area and then bolt the bolts to the horizontal actuator by tightening them to 11 N.m (97 lb in). The horizontal drive cable must be inserted into the actuator which requires applying pressure until a clear audible click is detected. Reinstallation of the motor support bracket must be followed by placing the front seat back into the vehicle.
Q: How to Change the Seat Motor for Vertical Adjustment on Chevrolet Malibu?
A: Before replacing the vertical seat adjuster motor make sure the seat reaches its highest position where the motor tension reduces. Begin by removing the seat in front position then disconnect all electrical wiring connections. Start by removing the fastener securing the seat motor and the roll pin securing the seat motor and proceed with removing the motor. Start by positioning the new seat motor and then fasten it using the roll pin for installation. Secure the fastener (fastener) first before tightening it to 7 N.m (62 lb in). After installation reconnect the electrical wiring and return the front seat to its place making sure the seat function works correctly.