One needs to collect j 8092 universal driver handle (J 8092), j 2619-01 slide hammer (J 2619-01), j 29369-1 bushing and bearing remover (J 29369-1), j 29369-2 bushing and bearing remover (2-3 inch) (J 29369-2), j 36609 axle tube bearing installer (J 36609), and j 45225 axle seal installer (J 45225) for replacing the front drive axle inner axle seal or bearing. Start the process by lifting the vehicle while draining the differential carrier assembly. The procedure to work on right side seal or bearing involves first removing the inner
Axle Shaft and housing assembly from the differential carrier case followed by taking away Clutch Fork assembly components along with the inner Axle Shaft from the inner Axle Shaft housing. Place the inner Axle Shaft housing inside a vise and clamp it down on the mounting flange only. Use either the j 29369-1 or j 29369-2 behind the inner Axle Shaft seal or bearing when required before you attach the j 2619-01 to remove these components. To remove the left-side inner Axle Shaft you need to vise the differential carrier assembly before extracting it with hammer and brass drift. Directorate of logistics standard items j 29369-1 or j 29369-2 will remove the inner Axle Shaft seal or bearing when used together with j 2619-01. To install the bearing on the right side use j 36609 and j 8092 then apply j 45225 together with j 8092 for new Axle Shaft seal installation. Thoroughly drive the inner Axle Shaft through its opening before assembling the Clutch Fork pieces while connecting the housing assembly to the differential carrier case. Perform the same process for the left-bearing and seal installation while making sure the inner differential case side gear accepts the inner Axle Shaft properly. After completing the front differential carrier assembly installation you should begin filling the differential carrier assembly with proper fluid before finally lowering the vehicle.