Other Name: Plate, End Gate And Rear Door Decoration; Plate Assembly, Cab And Load Carrier Outer Side Decoration; Plate, Cab And Load Carrier Outer Side Decoration
Position: Rear
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1991-1993 GMC Sonoma | Base, GT, SLE, SLS | 4 Cyl 2.5 L GAS, 6 Cyl 2.8 L GAS, 6 Cyl 4.3 L GAS
Other Name: Plate, Cab And Load Carrier Outer Side Decoration; Plate Assembly, Cab And Load Carrier Outer Side Decoration; Plate, End Gate And Rear Door Decoration
Position: Outer
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1994-2004 GMC Sonoma | SL, SLE, SLS | 4 Cyl 2.2 L FLEX, 4 Cyl 2.2 L GAS, 6 Cyl 4.3 L GAS
Other Name: Insert, Wheel Cover Appearance; Emblem, Wheel Cover Appearance
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1991-1993 GMC Sonoma | Base, GT, SLE, SLS | 4 Cyl 2.5 L GAS, 6 Cyl 2.8 L GAS, 6 Cyl 4.3 L GAS
GMC Sonoma Emblem
Our website offers an extensive catalog of genuine GMC Sonoma Emblem at unbeatable prices. Every OEM GMC Sonoma Emblem comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
GMC Sonoma Emblem Parts Questions & Experts Answers
Q: How to replace or repair an emblem/nameplate on GMC Sonoma?
A: Before installation you should apply tape to shields and use more tape for accurate placement. Use a J 25070 Heat Gun (J 25070) to heat the emblem/nameplate in circular motions for 30 seconds before pulling it from the panel using J 41409 Body Molding Removal Tool. When the tape stays on the panel surface do not touch it; use adhesive cleaner to remove tape from both surfaces and wipe with a clean lint-free cloth. Begin the replacement process when the tape cannot be used anymore. Place adhesive foam tape on the new emblem/nameplate backside and fix it onto the location. Use 3M(TM) Scotch Brite Molding Adhesive Remover Disk (3M(TM) P/N 07501) on body panels or wipe plastic panels with Varnish Makers and Painters (VMP) naphtha or a 50/50 alcohol and water solution on a lint-free cloth. Put the new emblem/nameplate in place by installing it in a clean dust-free environment. Prepare the spot for mounting with a lint-free cloth soaking the same cleaning solution and afterward let it dry completely. Place tape markers over the surface if you have no reference point. Heat the mounting surface between 80 and 105 degrees Fahrenheit while maintaining the emblem/nameplate temperature at 85 to 90 degrees Fahrenheit. Stick the emblem/nameplate to its marked position by pushing it directly on the heating surface with an even force. Take off the protective masking tape from the surface area.