Make sure this part fits

GM 25808854
Belt Weatherstrip, Rear Outer Driver Side

2002-2009 GM

Customer Questions & Expert Answers (23)
GM 25808854 Belt Weatherstrip, Rear Outer Driver Side
GM 25808854 Belt Weatherstrip, Rear Outer Driver Side
  • Part Description
    Sealing Strip Assembly-Rear Side Door Window Outer
  • Position
    Rear Outer Driver Side
  • Replaces
    15155433, 15176788, 15129778, 15089913, 15946951
  • Manufacturer
    General Motors
  • Manufacturer's Notes
    This part is discontinued.
Make sure this part fits
  • Vehicle Fitment

    Year Make Model Trim Engine
    2004-2007 Buick RainierCXL, CXL Plus6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
    2002-2009 Chevrolet TrailblazerBase, LS, LT, LTZ, North Face, SS6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
    2002-2009 GMC EnvoyDenali, SLE, SLT6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
    2002-2004 Oldsmobile BravadaBase6 Cyl 4.2 L GAS
    Warning: California's Proposition 65
  • Customer Questions & Expert Answers

    Q:
    Can you help me check if this 25808854 is the right part for my car? Posted by ChevyPartsGiant Specialist
    A:
    Please Select Your Vehicle model to see if part number 25808854 is suitable before ordering.
    Posted by ChevyPartsGiant Specialist
    Q:
    How do you secure the midgate sliding hinge panel for the 2005 Buick Rainier? Posted by Customer
    A:
    Slide the retaining clips up to secure the midgate sliding hinge panel.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What should be done after removing the sunroof window for the 2007 Buick Rainier? Posted by Customer
    A:
    Carefully take off the weatherstrip from the perimeter of the sunroof window.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What is the next action after removing the upper mold push-pins for the 2004 Buick Rainier? Posted by Customer
    A:
    Take off the end gate weatherstrip from the bulb flange of the moveable roof module.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    How do you remove the sealing strip for the 2006 Buick Rainier? Posted by Customer
    A:
    Lift upward on the rear edge of the sealing strip and remove it from the pinch-weld flange.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    How do you detach the mid gate weatherstrip for the 2004 Buick Rainier? Posted by Customer
    A:
    Detach the mid gate weatherstrip from the pinch-weld flange and window channel, and remove it from the vehicle.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    Where should the bond joint be positioned during installation for the 2005 Chevrolet Trailblazer? Posted by Customer
    A:
    The bond joint should be at the lower center of the door opening.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What needs to be done with the weatherstrip side retainer screws for the 2006 Chevrolet Trailblazer? Posted by Customer
    A:
    Remove these screws and take out the weatherstrip side retainer from the windshield pillar.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    How do you install the sealing strip for the 2002 GMC Envoy? Posted by Customer
    A:
    Place the sealing strip onto the pinch-weld flange at the rear edge of the door, ensuring it is fully seated.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    Where should the butt joint seam be installed for the 2003 Chevrolet Trailblazer? Posted by Customer
    A:
    Install the butt joint seam at the center of the bottom pinch-weld flange.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What is the final step after installing the new seal for the 2002 Chevrolet Trailblazer? Posted by Customer
    A:
    Close the hood.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    How should you position the weatherstrip during installation for the 2002 Chevrolet Trailblazer? Posted by Customer
    A:
    Position the weatherstrip to the pinch-weld flange and work down both sides towards the bottom center, ensuring not to stretch the weatherstrip.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What is the final step after installing the new weatherstrip for the 2008 Chevrolet Trailblazer? Posted by Customer
    A:
    Install the sunroof window back into the sunroof module assembly and verify that there are no air or water leaks.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What do you do after pulling back the front door sealing weatherstrip for the 2003 GMC Envoy? Posted by Customer
    A:
    Expose the weatherstrip side retainer screws.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    How do you install the new seal for the 2004 Chevrolet Trailblazer? Posted by Customer
    A:
    Position the new seal onto the air inlet grille panel and install it onto the studs.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What is the final step after installing the weatherstrip for the 2006 GMC Envoy? Posted by Customer
    A:
    Finally, close the liftgate.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What is the final step in the process for the 2007 GMC Envoy? Posted by Customer
    A:
    Reinstall the front door sill plate.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What do you do after removing the push pin retainers for the 2009 Chevrolet Trailblazer? Posted by Customer
    A:
    Pull back the weatherstrip to expose the weatherstrip side retainer screws.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What should you do after completing the installation for the 2004 GMC Envoy? Posted by Customer
    A:
    Close the front and rear side access doors.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What should be removed after opening the endgate and moveable roof for the 2005 GMC Envoy? Posted by Customer
    A:
    Remove the push-pins that secure the endgate weatherstrip upper mold from the moveable roof module.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    How do you begin replacing the auxiliary weatherstrip for the 2008 GMC Envoy? Posted by Customer
    A:
    Open the side doors on either the right or left side.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    What tool can be used to ensure full engagement of the weatherstrip for the 2009 GMC Envoy? Posted by Customer
    A:
    A rubber mallet.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    Q:
    How do you remove the weatherstrip for the 2004 GMC Envoy? Posted by Customer
    A:
    Squeeze the weatherstrip together and pull it out of the front door window channel.
    Posted by ChevyPartsGiant Specialist
    See expert answers on similar Weather Strip
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

OEM GM Belt Weatherstrip, Rear Outer Driver Side 25808854 Designed for Proper Fit and Performance

Original OEM GM parts deliver superior quality and meet all performance standards needed for optimal automotive operation. The authentic part identified by 25808854 Belt Weatherstrip, Rear Outer Driver Side is available in the market under the name GM Weather Strip. This genuine product has a full warranty coverage from the manufacturer available at all authorized GM dealers throughout the United States. This part 25808854 Belt Weatherstrip, Rear Outer Driver Side fits certain Chevrolet Trailblazer models, as well as GMC Envoy. Additionally, it is compatible with Buick Rainier and Oldsmobile Bravada models.
The original GM component designated by manufacturer part number 25808854 maintains top performance when functioning as the Sealing Strip Assembly-Rear Side Door Window Outer unit at its Rear Outer Driver Side. The component 25808854 is constructed from durable material and its dimensions span 25.1 x 2.2 x 0.9 inches while weighing 0.70 Pounds. The Direct Replacement component is ready in New condition to ensure full compatibility with your vehicle system. This component receives the designation of Sealing Strip, Side Door Window Glass. The part 25808854 has available replacement options 15155433, 15176788, 15129778, 15089913, 15946951. GM manufacturer provides a warranty that ensures reliable operation of this product. The Shipping Policy and Return Policy pages outline complete details regarding shipping procedures and return processes.
If you want to save money in the long run on maintenance and repairs, you should choose OEM products because they're of the top level of durability. Are you on the quest of finding GM parts, our site is worth a visit. We stock an endless selection of high-quality GM components including things like ignition coils all the way through to fan shrouds and all at prices that can not be matched. You have nothing to worry about because all our OEM parts are covered with a manufacturer warranty, which guarantees superior quality and value.