OEM 2004 Cadillac CTS ABS Control Module

2004 Cadillac CTS Parts Questions & Experts Answers

• Q: How to replace the ABS Control Module on 2004 Cadillac CTS?

  A: Begin ABS Control Module replacement by making sure you switch off the ignition component to stop equipment impairment. First clean the space surrounding the ABS Control Module and after that disconnect the coolant bypass valve from the Radiator keeping coolant inside. Prerequisite to disconnect the ABS Control Module electrical connector is to push the retainer with the hand while rotating the connector tab to the unlock position. The repair requires removal of 2 ABS Control Module to bpmv upper screws along with the front air deflector and the 2 ABS Control Module to bpmv lower screws after vehicle elevation and support. Due to unrepairability of the ABS Control Module, you need to replace it if you detect any faults. First clean the surface of the ABS Control Module/bpmv combination. Secure the internal pump motor connector on the new ABS Control Module then clean the bpmv seal surface before installing the device and verify proper connection of the motor connector before final installation. Secure the ABS Control Module on the bpmv using fresh ABS Control Module/bpmv screws while tightening them in 5 nm (44 inch lbs.) sequence. Finally, put the front air deflector back and lessen vehicle height before hooking up the ABS Control Module electrical connector while ensuring the locking tab is secure. After reconnecting the coolant bypass valve to the Radiator the technician must clear dtcs through the scan tool then execute the auto bleed procedure and possibly program the new ABS Control Module. The procedure concludes with performing the abs diagnostic system check while simultaneously recalibrating the brake pedal position sensor.