OEM 2005 Chevrolet SSR ABS Control Module

2005 Chevrolet SSR Parts Questions & Experts Answers

• Q: How to replace the ABS Control Module on 2005 Chevrolet SSR?

  A: Raising the vehicle constitutes the first step before ABS Control Module replacement. To start ABS Control Module replacement you must first detach both electrical connectors found on the ABS Control Module side before releasing the lock tab found on the connector located at the back of the ABS Control Module using a long flat-bladed screwdriver. Check that TORX(R) screw heads maintain clean condition before installing the T 25-TORX(R) bit. Replace both ABS Control Module and brake pressure modulator valve (BPMV) if the 25-TORX(R) screws are unremovable or damaged. Remove the 4 mounting screws of the ABS Control Module with a T 25-TORX(R) bit while applying light force if needed but refrain from applying force to either component. Install a new ABS Control Module to the BPMV by not reusing the mounting screws and refraining from using RTV or any other sealing materials on ABS Control Module gasket surfaces. Secure the ABS Control Module onto the BPMV by tightening its four new T-25 TORX(R) screws to 5 Nm (39 inch lbs.) through an X-pattern. Proceed by connecting electrical connectors located on the ABS Control Module sides as well as the one on its rear surface before lowering the vehicle. The calibration process for tires ends with the use of Scan Tool Tire Size Calibration.