Other Name: Plate, Rear End Panel And Tailgate; Emblem, End Gate And Rear Door Decoration; Emblem,Rear End Panel And Tailgate; Plate,Rear End Panel And Tailgate
Position: Rear
Replaces: 10372469, 25739124, 25762472
Item Weight: 0.30 Pounds
Item Dimensions: 4.9 x 1.6 x 0.3 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 10387855
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Other Name: Plate, Rear End Panel And Tailgate; Plate,Rear End Panel And Tailgate
Position: Rear
Item Weight: 0.30 Pounds
Item Dimensions: 5.3 x 1.3 x 0.3 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 10334040
Warranty: This genuine part is guaranteed by GM's
factory warranty.
More Info
Fits the following 2006 Cadillac SRX Submodels:
Base | 8 Cyl 4.6 L GAS
2006 Cadillac SRX Emblem
With a comprehensive array of OEM 2006 Cadillac SRX Emblem, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2006 Cadillac SRX Emblem are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.
2006 Cadillac SRX Parts Questions & Experts Answers
Q: How to replace the emblem/nameplate on the liftgate on 2006 Cadillac SRX?
A: To change the liftgate emblem begin by preparing three tools: a Heating Device (J 25070) Switch, 3M(TM) Scotch Brite fabric adhesive remover pad size 3M(TM) P/N 07502 or similar body panel product as well as a clean rag and either Varnish Makers and Painters (VMP) naphtha or 50/50 isopropyl mixture for plastic surfaces. Protect the emblem/nameplate with tape as you set its position. Heat the emblem/nameplate with the Heat Gun (J 25070) in circular motions directed from 152 mm (6 in) for 30 seconds to detach it from its location. Gently loosen the emblem/nameplate from its frame using small plastic flat tool to preserve paint quality. Thoroughly take off all remaining glue from the area. Set up a clean and dry space for the installation and use marking tape to measure 130mm from the horizontal edge and 80mm from the vertical edge of the liftgate as specified by the manufacturer. For export units mark 12mm from the bottom of the SRX emblem. To determine the place without tape markings measure 0.2 inch and 0.9 inch from the horizontal top edge of the liftgate applique. Heat the liftgate area using the Heat Gun J 25070 to 27-41°C (80-105°F) and keep the emblem/nameplate at 29-32°C (85-90°F). When placing the emblem/nameplate on the surface eliminate contact with the adhesive layer and peel away the protective film before attaching it to the marked points and pushing it firmly into place. Press down evenly across the area and confirm correct bonding after placing the sticker in position. Finish by running your hands over any stuck cloth tapes before taking it off from the surface.