Other Name: Plate, Rear End Panel And Tailgate; Emblem, End Gate And Rear Door Decoration; Emblem,Rear End Panel And Tailgate; Plate,Rear End Panel And Tailgate
Position: Rear
Replaces: 10372469, 25739124, 25762472
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2006-2009 Cadillac SRX | Base | 6 Cyl 3.6 L GAS, 8 Cyl 4.6 L GAS
Other Name: Cap-Hub Polished 19" Wheels *Black Backgr; Wheel Center Cap; Hub Cap; Emblem; Emblem, Wheel Cover Appearance; Cap, Wheel - Front And Rear; Cap, Wheel Trim
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2007-2008 Cadillac SRX | Base | 6 Cyl 3.6 L GAS, 8 Cyl 4.6 L GAS
Cadillac SRX Emblem
Our website offers an extensive catalog of genuine Cadillac SRX Emblem at unbeatable prices. Every OEM Cadillac SRX Emblem comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Cadillac SRX Emblem Parts Questions & Experts Answers
Q: How to replace the liftgate emblem and nameplate on Cadillac SRX?
A: For this replacement job you need the Heat Gun model J 25070 and other tools. You need to cover and position the nameplate region with tape before starting. Heat the emblem/nameplate using the Heat Gun (J 25070) by moving it in circles for 30 seconds when kept 6 inches away from the surface. Use a tiny plastic tool to pull off the emblem/nameplate since it avoids paint damage. Use a 3M Scot Brite Molding Adhesive Remover Disk (Part Number 07502) to remove body panel residues while cleaning plastic panels requires a lint-free cloth with 3M VMP naphtha or a mixture of 50% isopropyl alcohol and water. Use the installation space for the back panel while preparing a clean and dry area. If no marking present use tape and measure 5.12 inches (130 mm) below the panel top and 3.12 inches (80 mm) from each panel side with an added 0.5 inches (12 mm) extension from bottom edge of SRX mark for export models. Use the Heat Gun (J 25070) to make the mounting surface reach 27-41°C (80-105°F) and adjust the temperature when needed. Maintain the emblem/nameplate to around 29-32°C (85-90°F). Push away the protection film before placing the emblem/nameplate at its marks. Press it strongly to the surface without letting the adhesive stick to your fingers. Push the emblem gently while checking the entire surface for correct attachment and wiping away loose tape before removing it from the mounting area.