OEM 2008 Chevrolet Corvette Fuel Level Sensor

2008 Chevrolet Corvette Parts Questions & Experts Answers

• Q: How to replace the Fuel Level Sensor on the right side on 2008 Chevrolet Corvette?

  A: The first step to replace the Fuel Level Sensor on the right side requires removal of the module from within the Fuel Tank. You should press the connector position assurance (CPA) while using your thumb and move it down to disconnect the electrical connector from the module before removing the sender wires from the connector. To replace this level sender push the lock tab at the top and slide it out while directing wires to fit within the back opening of the level sender body. Place the new level sender assembly into the slot before guiding the wires near the regulator ground wire to connect them with the electrical connector. Connect the level sender wires into the open slots within the electrical connector that attaches to the flange. To check the level sender resistance use an ohmmeter because the empty stop must show 38.5-41.5 ohms and the full stop must indicate 247-253 ohms while maintaining continuous resistance across the entire measuring range. Measure the resistance across the level sender while the tank is upright so the screen displays empty and next check the resistance reading for full while the tank is on its side. To validate empty stop resistance the tank needs to be positioned upright for checking that the level sender functions without interference from internal tank lines.