Other Name: Emblem, End Gate And Rear Door Decoration; Plate Assembly, Cab And Load Carrier Outer Side Decoration; Plate, End Gate And Rear Door Decoration
Position: Rear
Replaces: 15207239
Item Weight: 0.30 Pounds
Item Dimensions: 2.0 x 14.5 x 0.4 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 10355873
Warranty: This genuine part is guaranteed by GM's
factory warranty.
More Info
Fits the following 2009 GMC Canyon Submodels:
SL, SLE, SLT, WT, Z71 Fleet, Z71 SL, Z71 SLE, Z85 SL, Z85 SLE | 4 Cyl 2.8 L GAS, 4 Cyl 2.9 L GAS, 5 Cyl 3.5 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
Other Name: Emblem, End Gate And Rear Door Decoration
Position: Rear
Item Weight: 0.30 Pounds
Item Dimensions: 4.3 x 1.6 x 0.3 inches
Condition: New
Fitment Type: Direct Replacement
SKU: 15926161
Warranty: This genuine part is guaranteed by GM's
factory warranty.
More Info
Fits the following 2009 GMC Canyon Submodels:
SLT | 4 Cyl 2.9 L GAS, 5 Cyl 3.7 L GAS, 8 Cyl 5.3 L GAS
2009 GMC Canyon Emblem
With a comprehensive array of OEM 2009 GMC Canyon Emblem, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2009 GMC Canyon Emblem are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.
2009 GMC Canyon Emblem Parts Questions & Experts Answers
Q: How to replace the pickup box side emblem and side rear nameplate on 2009 GMC Canyon?
A: Mark the surface with tape to help you protect the emblems during replacement. Firmly hold the J 25070 Heat Gun at 152 mm (6 in) and heat the decal for 30 seconds by moving the gun in small circles. A plastic tool will protect the surface as you pull off the decal carefully. Then clean the surface with 3M(TM) P/N 07501 or equivalent model adhesive remover. Use VMP naptha to clean the area and detach the tail lamp before starting. Apply tape and set the top of the decal at 178.5 mm (7.03 in) above the pickup box edge. Also position the decal's lowest point 66.3 mm (2.61 in) behind the tail lamp sheet metal edge when there is no manufacturer marking visible. Use the J 25070 Heat Gun to heat the door surface until it reaches at least 21°C (70°F) and avoid touching the adhesive side of the decal. Gently place the front end of the decal on painted surface as you remove the backing then roll the decal by hand to bond it properly. Check if the decal sticks correctly then take away the tape and install the tail lamp again.