OEM 2010 Cadillac DTS Wheel Speed Sensor

2010 Cadillac DTS Parts Questions & Experts Answers

• Q: How to replace the rear wheel speed sensor on 2010 Cadillac DTS?

  A: Begin by switching off the ignition system to perform the Wheel Speed Sensor replacement. Lift your vehicle after that. To begin utilize the ignition controls then lift the vehicle. Disconnect the Wheel Speed Sensor connector at its Wheel Speed Sensor right before removing the rear wheel. The Wheel Speed Sensor needs disposal at this stage since it cannot return for use. Place the new Wheel Speed Sensor connector towards the brake caliper and put the Wheel Speed Sensor on the hub assembly properly. Place the j 44252 abs sensor installer on the Wheel Speed Sensor and pull the tool to position the sensor correctly at the Wheel Hub. For testing purposes you must connect a dmm device to the Wheel Speed Sensor port while manually moving the wheel to check if the sensor produces more than 100mv output voltage signals. Then attach the Wheel Speed Sensor connector and put back the rear wheel before lowering the vehicle.