Q: How to replace the steering wheel on Buick LaCrosse?
A: Before installing the Steering Wheel users must first disable the sir system followed by turning off the ignition key. Mark the Steering Wheel hub along with its matching slash mark position on the Steering Shaft. Now that the wheel nut is loose extend it to touch the Steering Shaft end. Install the Steering Wheel puller (J 1859-A) together with the Steering Wheel puller legs (J 42578) on the Steering Wheel before using this tool to separate the Steering Wheel from the Steering Shaft. Start by removing the puller tool after you've successfully taken off the Steering Wheel nut and Steering Wheel hardware and separated the sir connector from the wheel base. To install the sir connector feed it through the Steering Wheel then match the scribe mark to the slash mark on the Steering Shaft before installing the Steering Wheel. Follow by installing the Steering Shaft nut but tighten it to 41 n.m (30 lb ft). Return the inflatable restraint Steering Wheel module to its position then turn the sir system back on. Inspection of the horn along with the Steering Wheel components and their controls ends the procedure.
Q: How to replace the steering wheel on Buick LeSabre?
A: Before taking out the Steering Wheel, firstly deactivate the sir system because sir is associated with the inflatable restraint Steering Wheel module. Remove the Steering Wheel electrical connector and, if fitted, the weight block from the Steering Wheel base. Then take away the Steering Wheel retaining nut and take a mark of the alignment way on the Steering Shaft and also on the Steering Wheel. Attach the Steering Wheel puller legs (J42578) and the Steering Wheel puller (J1859-A) on the Steering Wheel, and utilize these tools to eliminate the Steering Wheel and the Steering Column away from one another. After taking away the tools, pass the wires through the new Steering Wheel with the sign on the Steering Wheel being equal to that on the shaft and then put it in. Mount the Steering Wheel retaining nut and tighten it to 41 nm (30 ft. Lbs), add weight block if applicable. Reattach the Steering Wheel electrical connector, put on the inflatable restraint Steering Wheel module, and then turn on the sir system.
Q: How to replace the steering wheel on Buick Regal?
A: To remove the Steering Wheel, first, disable the sir system and put the ignition in off position. Take off the inflatable restraint Steering Wheel module and scribe and alignment mark on the Steering Wheel hub to this mark, align it with the slash mark lying on the Steering Shaft. Loosen the steering-wheel nut, and seat it flush with the end of the Steering Shaft. Fit the j 1859-a Steering Wheel puller (J 1859-A) onto the j 42578 Steering Wheel puller legs (J 42578) connected to the Steering Wheel and use this assembly to dislodge the Steering Wheel from the Steering Shaft. Remove the Steering Shaft puller, Steering Shaft nut, and Steering Wheel, and also un-route sir connector from the Steering Wheel. For the installation, route the sir connector through the Steering Wheel, align it with the slash mark on the Steering Shaft, and put on the Steering Wheel. Fasten the Steering Shaft nut with 45 nm (33 ft. Lbs.). Install the inflatable restraint Steering Wheel module and turn unpaved the sir system. Finally, check the horn, Steering Wheel, and Steering Wheel controls.