Other Name: Sensor, Multi Portion Fuel Injection Throttle Position; Sensor Kit, Multi Portion Fuel Injection Throttle Position; Throttle Body Sensors; Computer Control Sensors
Replaces: 17112404, 17112679, 17087653
Fits the following Buick Models:
Century | 1995-1996 | Limited, Special | 4 Cyl 2.2 L GAS
Roadmaster | 1991-1993 | Base, Estate Wagon, Limited | 8 Cyl 5.0 L GAS, 8 Cyl 5.7 L GAS
Q: How to service and repair the Throttle Position Sensor on Buick LeSabre?
A: Begin the service work of the Throttle Position Sensor by removing the fuel injector sight shield afterward disconnecting the throttle position (TP) sensor electrical connector from its positioning. After disconnecting the tp sensor electrical connector from the Throttle Body you should remove the tp sensor attaching screws to take out the sensor. Normal throttle valve closure position must be confirmed before the tp sensor can be inserted into the Throttle Body assembly. The installation requires application of thread-locking compound loctite 262® (GM P/N 1052624) or equivalent on screws followed by tightening the two tp sensor attaching screws to 2 n.m (18 lb in). Connect the tp sensor electrical wiring connector before replacing the fuel injector sight shield.
Q: How to service the Throttle Position Sensor on Buick Regal?
A: In order to service the Throttle Position Sensor, take off the injector sight shield and disconnect tp sensor electrical connector. Next, loosen the two tp sensor attaching screws and pull out the tp sensor. For installation, you put the tp sensor on the Throttle Body assembly and you use a thread-locking compound as loctite 262(R) and gm part no.1052624, and an equivalent on screws. Anchors the tp sensor attaching screws to 2.0 n.m (18 in lb) and reconnects the tp sensor electrical connector and lastly, reinstall the injector sight shield.
Q: How to service the Throttle Position Sensor on Buick Century?
A: Between servicing the Throttle Position Sensor, one has to turn off the ignition and remove (unplug) the tp sensor electrical connector. Unscrew 2 tp sensor attaching screws and pull out the tp sensor with its o-ring. For the installation, begin by installing the new tp sensor o-ring. Install the tp sensor located on the Throttle Body assembly with throttle valve in the normal closed idle position. A thread-locking compound like loctite (R) 262, gm part no. 1052624, or an equivalent should be applied to the 2 tp sensor attaching screws before reinstall. Tightening the screws to 2.0 n.m (18 lb in), the tp sensor electrical connector must be reconnected.