Q: How to properly service and replace the oil filter on a Cadillac CTS?
A: You should start by turning off the ignition and remove any front compartment sight shield before starting to replace the engine oil and Oil Filter components. A 6-point socket can remove the Oil Filter cap but allow normal draining oil from the Oil Filter chamber within the adapter housing. Do not replace the adapter for this natural condition. First, remove the old Oil Filter cartridge then support the vehicle at a proper height. A suitable drain should be placed under the oil pan Drain Plug for complete oil drainage after removing the plug. The vehicle requires a new o-ring seal for the oil pan Drain Plug before installing it at 20 nm (15 lb ft). The vehicle can then be lowered. When installing the new Oil Filter cartridge add engine oil to the threads of the cap to stop damage and enhance future unscrewing. Install the Oil Filter cap with a 6-point socket while applying 25 nm (18 lb in) torque setting. Slide the oil fill cap onto its place before adding engine oil of the correct type and amount. Reinstall the front compartment sight shield according to necessary procedures.
Q: How to replace the engine oil and oil filter on Cadillac SRX?
A: Start by turning off the engine ignition. A six-point socket can eliminate the Oil Filter cap while recognizing the oil flow from the filter chamber in the adapter housing as a normal condition which does not require insertiing a new adapter. Begin by removing the Oil Filter cartridge while also lifting and using support to elevate the vehicle. After positioning a suitable drain under the oil pan Drain Plug remove the plug while the oil drains completely out of the system. Replace the new o-ring seal on the oil pan Drain Plug and fasten it to a torque of 20 n.m (15 lb ft). Before adding the new Oil Filter cartridge to the vehicle position the Oil Filter cap threads with clean engine oil for protection against damage and easier replacement in the future. You should tighten the Oil Filter cap with a six-point socket until you reach 25 n.m (18 lb ft). Apply the oil fill cap while you add the recommended oil type and proper amount according to the fluid and lubricant recommendations and approximate fluid capacities.
Q: How to Replace an Engine Oil and Oil Filter on Cadillac XLR?
A: The first step begins with raising and supporting the vehicle when changing engine oil and Oil Filter. Place your drain pan below the engine oil Drain Plug and then take out the plug from its location. Check and clean the Drain Plug before replacing it when necessary. Examination of the Oil Pan sealing surface must also occur and the Oil Pan requires replacement if needed. Afterward clean the sealing area on the Oil Filter adapter before inspecting whether replacement of the adapter is needed. Pour oil inside the new Oil Filter before applying a slight coat of clean oil to its gasket. Begin by installing the new Oil Filter then tighten it while letting the gasket reach the mounting surface until it achieves 3/4 to 1 full turn. Install the engine oil Drain Plug with a torque of 20 n.m (15 lb ft). Before adding new engine oil to the vehicle lower it and inspect fluid levels and follow lubricant guidelines. After the engine starts you should check for any oil leak occurrences.