OEM Cadillac SRX Steering Angle Sensor

Cadillac SRX Steering Angle Sensor Parts Questions & Experts Answers

• Position Sensor
  15231652
  Q: What tools are required to service and repair the Steering Angle Sensor, and what are the steps involved in the process on Cadillac SRX?

  A: A pivot pin remover (J 21854-01) serves as the essential tool for Steering Angle Sensor maintenance including Steering Angle Sensor or Steering Shaft lower bearing replacement. Pivot pin remover (J 21854-01). Start your process by disabling the sir system. Initiate the service by removing the Steering Column followed by detachment of the turn signal switch housing. After the Steering Column support assembly has its tilt spring removed use the pivot pin remover (J 21854-01) to uninstall two pivot pins from the assembly. Remove the boot seal. Move forward with removing first the Steering Shaft seal then the sensor retainer unless the sensor is absent. The procedure requires discarding of the sensor locator and sensor assembly. Installation requires installing the sensor retainer followed by the Steering Shaft seal if the sensor is not present. Assemble the sensor assembly first and then the sensor locator and boot seal following proper alignment to the 9 o'clock position. Put the Steering Shaft assembly into the Steering Column tilt head assembly followed by putting both parts into the Steering Column jacket assembly. Steering Column support assembly replacement must occur after three stake incidents. Related gm p/n 12346293 (Canadian P/N 992723) lubrication complements the mounting of 2 pivot pins onto the Steering Column support assembly where staking happens across 3 locations. The installation process includes returning the vehicle components to their place and enabling the sir system.