Q: How to Replace Automatic Transmission Shift Levers on Chevrolet Aveo?
A: The Automatic Transmission Shift Levers replacement process needs negation of the Battery Cable power first. You must remove the floor console followed by disconnecting wiring harness connectors from the Automatic Transmission Shift Levers. The control cable adjusting nut should be loosened first before removing the control cable from its connection with the Automatic Transmission Shift Levers assembly. Unfasten the mounting bolts from the Automatic Transmission Shift Levers assembly for its removal. Secure the Automatic Transmission Shift Levers assembly by inserting its mounting bolts then tighten them to 8 nm (71 inch lbs.). The control cable should be attached to the Automatic Transmission Shift Levers assembly while the control cable adjusting nut should be tightened to 8 nm (71 inch lbs.). The harness connector needs reattachment while adjusting the control cable before reinstalling the floor console followed by reconnection of the negative Battery Cable.
Q: How to Service and Repair Automatic Transmission Shift Levers on Chevrolet Impala?
A: The replacement process of the shift lever starts by removing the steering column trim covers. Connectors for shift lever electrical signaling must be detached from the base of the steering column. First cut off the shift lever screw attached to the shift lever before pulling the shift lever away from its connection to the linear shift assembly. Shift lever seal can be transferred during the process. Installation of the shift lever requires allowing the linear shift assembly to grab it then executing slow fastener procedures. The installation of shift lever screw should occur on shift lever while tightening to 20 nm (15 lb ft). You should refit the electrical connector for the shift lever located at the steering column base and install both steering column trim panels.
Q: How to Service and Repair Automatic Transmission Shift Levers on Chevrolet Malibu?
A: The first step to change the Automatic Transmission Shift Levers requires users to activate the park brake and wheel chocking process. Unplug the transmission shift lever cable terminal where it connects to the transmission manual shift lever pin. At the same time press the locking tabs until the transmission shift lever cable releases from its bracket connection. You should first remove the transmission shift lever nut to access the transmission shift lever for extraction. When installing the transmission shift lever you must first install it following the fastener notice. Mount the transmission shift lever nut before securing it to 20 n.m (15 lb ft). Route the transmission shift lever cable from the cable bracket while using it to connect its terminal section to the transmission manual shift lever pin. Conduct a final examination of the shift lever cable setting.