Q: How to replace the Hydraulic Hose (M86) on Chevrolet Cobalt?
A: As a first step for hydraulic Clutch Hose/pipe (M86) replacement begin by removing the ubec while maintaining awareness about brake fluid reaction to paint and electrical elements. A shop towel placed under the Clutch Master Cylinder and brake master cylinder reservoir will catch any escaping fluid. To begin the replacement of the hydraulic Clutch Hose/pipe (M86) first disconnect the Clutch Hose from the Clutch Master Cylinder and brake master cylinder reservoir then disconnect the clutch line at the clutch actuator cylinder and the transaxle while draining fluid into a suitable container. To install the system first make sure the clutch line locks before connecting the clutch line to both the Clutch Master Cylinder and transaxle then complete the installation by connecting the Clutch Hose to the clutch actuator cylinder and brake master cylinder reservoir. After properly disposing of the shop towel you should install the ubec. Pump dot 3 hydraulic fluid into the brake/clutch reservoir until it reaches the recommended mark before performing a clutch hydraulic system bleeding operation.
Q: How to replace the hydraulic hose on Chevrolet HHR?
A: To avoid the hydraulic Clutch Hose, remove ubec first. It would be prudent to be watchful of the effects of brake fluid on paint and electric parts. Put a shop towel under the Clutch Master Cylinder and brake master cylinder reservoir to capture the escape of fluids. Remove the Clutch Hose from the Clutch Master Cylinder and brake master cylinder reservoir, and disconnect the clutch line from the clutch actuator cylinder and the transaxle, draining the fluid into the suitable container. For installation, lock the clutch line in place and connect the clutch line to the Clutch Master Cylinder and the transaxle and after that connect the Clutch Hose to the clutch actuator cylinder and brake master cylinder reservoir. To start, take off the shop towel and throw it in the appropriate location. Replace the ubec and fill up the brake/clutch reservoir with dot 3 hydraulic fluid as required. Bleed the clutch hydraulic system at last.
Q: How to replace the hydraulic hose for the clutch on Chevrolet SSR?
A: The first step is to move the electrical harness at the master cylinder, followed by taking off the line clip and hydraulic line. Then, raise the vehicle and take out the wheelhouse liner, and then remove the line clip and hydraulic line from the clutch concentric actuator. As you install the hydraulic line, first put it on the clutch concentric actuator, use the clip to secure it, and reinstall the wheelhouse liner. Bring the vehicle down, join the hydraulic line to the master cylinder, fasten it using the line clip, and afterwards place the electrical harness back. When you have finished, pour fluid into the master cylinder and bleed the entire hydraulic system.