Start by removing the air cleaner outlet resonator before you start replacing the evaporative emission canister purge solenoid valve. Begin the replacement by disconnecting the evaporative emission (EVAP) canister purge solenoid valve tube quick connect fitting from its connection to the evap purge solenoid valve then position the tube to the side as an obstruction. Disconnect the engine wiring harness electrical connector from the evap purge valve solenoid followed by bolt removal for the evap canister purge solenoid valve from the upper
Intake Manifold surface. When needed, take out the upper Intake Manifold-mounted evap canister purge solenoid valve o-ring seal. Before installing the evap canister purge solenoid valve o-ring seal users should apply clean engine oil for easier installation outreach. Place the evap canister purge solenoid valve inside the upper Intake Manifold next install the evap canister purge solenoid valve bolt with 10 n.m (89 lb in) torque. The wiring operations commence with evap purge valve solenoid electrical connector connection to the solenoid followed by installing evap canister purge solenoid tube placement before attaching the tube quick connect fitting to the evap purge solenoid valve. The last step involves the installation of the air cleaner outlet resonator.