OEM Chevrolet Silverado 3500 Classic Power Window Switch

Chevrolet Silverado 3500 Classic Power Window Switch Parts and Q&A

• Window Switch, Rear Driver Side
  15206533
  Q: How to replace the Door Lock Switch and Power Window Switch on the driver side on Chevrolet Silverado 3500 Classic?

  A:

  The first step for replacing the driver side Door Lock and side window switch involves removing the front door trim panel before disconnecting electrical connectors. First dismantle the front door panel by removing the screw that maintains the switch panel bezel then separate the bezel carefully with a flat-bladed tool. The wide plastic flat-bladed tool should be used to disengage retaining clips along both door module sides before getting the door module out of the switch panel bezel. Position the door module inside the switch panel bezel so it will snap-lock before you connect the bezel with the module to its designated spot on the door panel. Secure the switch panel bezel retaining screw onto the front door panel while torquing it to 2 n.m (18 lb in). Join all electrical connections before you return the front door trim panel back into position. Proceed with programming the door module when the vehicle contains camper mirrors. You will find programming and setup data in corresponding documentation.
• Window Switch, Passenger Side
  19115820
  Q: How to replace the door lock switch and power window switch on the passenger side on Chevrolet Silverado 3500 Classic?

  A:

  The first step to swap the passenger-side Door Lock and window switch involves removing the front door trim panel followed by removing one screw which holds the switch panel bezel to the front door trim panel. Finish by detaching the switch panel bezel from the door panel using a flat-bladed tool. The switch panel bezel removal begins with unscrewing the fixation screw between the front door trim panel and switch panel bezel. After screw removal, detach the switch panel bezel from the door panel using a flat-bladed tool. A wide plastic flat-bladed tool should be used to release retaining clips located on each side of the door module which enables door module removal from the switch panel bezel. Insert the door module into the switch panel bezel while it clicks into position before restoring the switch panel bezel together with the module back to the door trim panel. Install the screw that maintains the switch panel bezel to the front door trim panel making it tight at 2 n.m (18 lb in). Proceed with the front door trim panel replacement before executing setup and programming procedures according to guidelines found for these tasks.